Search
×
Keyword
PhalloBoards - An Online Community to Discuss Penile Girth Enhancement

TOPIC: Pumping and PMMA

Re: Pumping and PMMA

13 years 10 months ago #1275668012
i would like to know has anyone done Hanging after having PMMA also?

Please Log in or Create an account to join the conversation.

Re: Pumping and PMMA

13 years 10 months ago #1275669554
do you guys think pumping while Hanging will render length results? also can you message man or sizemic give me a recommendation on a good penis pump. I have the bathmate and its very shitty and don't work. also cn i use it while Erect? any think its possible to gain volume pumping.

Please Log in or Create an account to join the conversation.

Re: Pumping and PMMA

13 years 10 months ago #1275663923
  • 's Avatar
  • Pending Email Verification
  • Pending Email Verification
  • Thanks: 0
I think Hanging produces better length results. If i could hang and get PMMA, I would consider it.

I would imagine it you got Erection maintained it, while in tube. Then I guess, just guess it you pump on a low pressure it sure be okay, with breaks in between. But I would imagine you would be able to do high pressure, or long periods.


Has anyone here done Hanging and PMMA?

Please Log in or Create an account to join the conversation.

Re: Pumping and PMMA

13 years 10 months ago #1275306316
Hey guys basically here is what I know.

Wade said that there shouldn't be any problem pumping after PMMA in regards to loss of size or anything like that. "Once the material is there, it's there." Were his words.

But on my last round he noticed I have slight ridges at the base (wade called them dog ears) and he said that could happen with people who pumped a lot before PMMA (since pumpers often develop dog ears themselves.. Extra skin etc). I feel like more pumping would make it worse because it would likely encourage lifting of the ears more.

Hopefully that makes sense.

Please Log in or Create an account to join the conversation.

Re: Pumping and PMMA

13 years 10 months ago #1275724896
  • 's Avatar
  • Pending Email Verification
  • Pending Email Verification
  • Thanks: 0
The bathmate will work very well if you use it correctly. How are you using it because following the instructions didn't work at all for me. See my thread on the bathmate for info on how I use it. Hope it helps!

Please Log in or Create an account to join the conversation.

Re: Pumping and PMMA

13 years 10 months ago #1275996786
I use a hand pump and have enjoyed enhanced temporary Girth with no issues. I've pumped after Hanging in hopes that the added blood flow will aid in healing. Regardless of the actual benefits or lack of I've not had any negative issues result from pumping.

Please Log in or Create an account to join the conversation.

Re: Pumping and PMMA

13 years 10 months ago #1275289207
Any success with PM´ing him? Would be quite interesting to know

Please Log in or Create an account to join the conversation.

Re: Pumping and PMMA

13 years 10 months ago #1291819131
Absolutely! I hang for 10 - 15 minutes and follow with a 5 minute pump session. The amount of vacuum pressure and the time spent in the pump must be carefully monitored to prevent damage and ensure success. I've gained another .25" in EL using this technique. Now a solid 8.25" NBPEL x 7.5" EG. BPEL is 8.5".

Please Log in or Create an account to join the conversation.

Re: Pumping and PMMA

13 years 10 months ago #1275191462
If I recall correctly there is a user called Sizemik on this site who does this. Or did it only before PMMA, I am not sure.

Try sending him a PM

I think to remember that I read about Wayne or Dr C telling that pumping post PMMA is no problem but one should wait a long time ( several months )

Please Log in or Create an account to join the conversation.

Re: Pumping and PMMA

13 years 10 months ago #1275337128
I have pumped randomly a couple times after my PMMA, for one I can't really fit in my old tube so that dampers my enthuiasm a bit. But also I tend to bruise easier, I get the little red spots of burst veins more often even under a bit of low pressure. The single biggest deterrent though is that with the PMMA added to the top of my shaft right at my exit point, the tube pushes badly on that and causing some internal aching for a bit after.

I do get a nice hang and fullness after as typical for several hours, but then I think it gets worse than normal for the following day.

Please Log in or Create an account to join the conversation.

Re: Pumping and PMMA

13 years 10 months ago #1275290546
olafspo wrote: Any success with PM´ing him? Would be quite interesting to know

Thanks Olafspo
I will get on it now. Lots going on these last few weeks
Will report back with what he had to say!

Please Log in or Create an account to join the conversation.

Re: Pumping and PMMA

13 years 10 months ago #1291816887
So you can pump after PMMA?

Please Log in or Create an account to join the conversation.

Re: Pumping and PMMA

13 years 10 months ago #1275305169
Sizemic mentioned that he had only pumped twice since his last PMMA round. He is worried that he could develop "dog ears" or a flare at the base if he does it anymore. He mentioned that Wade told him that such side effects are pretty common with guys who pump with PMMA.
The only reason I am contemplating pumping is because I want to try to increase the size of my glans.

Please Log in or Create an account to join the conversation.

Re: Pumping and PMMA

13 years 10 months ago #1275306456
Sizemic wrote: Hey guys basically here is what I know.

Wade said that there shouldn't be any problem pumping after PMMA in regards to loss of size or anything like that. "Once the material is there, it's there." Were his words.

But on my last round he noticed I have slight ridges at the base (wade called them dog ears) and he said that could happen with people who pumped a lot before PMMA (since pumpers often develop dog ears themselves.. Extra skin etc). I feel like more pumping would make it worse because it would likely encourage lifting of the ears more.

Hopefully that makes sense.

Thanks Sizemic

Please Log in or Create an account to join the conversation.

Re: Pumping and PMMA

13 years 10 months ago #1275723747
I use a 2X9in Lapdist.com regular cylinder (way too small now, I need to upgrade eventually) and hand pump. Some people buy a cheap cylinder (within reason) and then just replace the shitty pumps that often come with them with a better one, as you want one with a measurement method on it.

I'm going to start to hang again in a bit or so (once Im unlazy enough to go buy some new weights), and I'll let you know how it goes. I think its possible and should be fine to make some light or normal lig stretch gains.

Please Log in or Create an account to join the conversation.