TOPIC: Taking the PMMA plunge
Re: Taking the PMMA plunge
13 years 6 months ago #1276446228Please Log in or Create an account to join the conversation.
Re: Taking the PMMA plunge
13 years 6 months ago #1276465092- Dance_With_Dragons
-
Topic Author
- Offline
- General
-
- Posts: 291
- Thanks: 0
I have been with over 100 women, and been f buddies to a hell of a lot of long term repeat customers, so I can only figure this: I am either amazingly good looking or the most highly skilled man with a small penis ever to live
In all seriousness, 4.25 MSEG is way below average and I'm so glad I'm going in for this procedure next week. Onward and upward fellas! I hope dr C is willing to max out my CCs and concentration!
Please Log in or Create an account to join the conversation.
Re: Taking the PMMA plunge
13 years 6 months ago #1276466820But having a big hook sure helps on big mouthed fish
I'll be going after you buddy! I wish us both luck!!
Please Log in or Create an account to join the conversation.
Re: Taking the PMMA plunge
13 years 6 months ago #1276467548Please Log in or Create an account to join the conversation.
Re: Taking the PMMA plunge
13 years 6 months ago #1276467841Please Log in or Create an account to join the conversation.
Re: Taking the PMMA plunge
13 years 6 months ago #1276484948- Dance_With_Dragons
-
Topic Author
- Offline
- General
-
- Posts: 291
- Thanks: 0
Please Log in or Create an account to join the conversation.
Re: Taking the PMMA plunge
13 years 6 months ago #1276486835Best of luck...
Please Log in or Create an account to join the conversation.
Re: Taking the PMMA plunge
13 years 6 months ago #1276497087If you proceed, I'd show these photos to Dr C, along with those of other members who are tightly cut and explain you aesthetic fears. If I were you I wouldn't risk a big gain in round one and ask Dr C to be very conservative with injecting at the base and above the circ line.
I tired to illustrate what I think you should ask for in the photo. Ask for 10% solution and less than 20cc of it (i'd ask for around 15-16cc). The way you skin is, means that the mid shaft is going to more give, so you want it tapered at either end. The black line illustrates the depth or amount of PMMA that I think should be injected. So point B is has much more PMMA, than at point A and C. Basically point B is the high point and it should taper down on either side to points A and C. Don't have any injected above the green line as the skin in that area is so thin and tight that it will certainly get compressed back and cause an obvious ring.
I'd treat the first round as more of a test session and forget trying to get big gains. Don't take my opinion, look at the other guys who are tightly cut. It is really hard to get PMMA to settle in the circ scar area and avoid the ring. I know very little about PMMA or bioplasty in general, but anyone who has been a member here and followed progress reports can see that injecting tightly cut guys is difficult and the aesthetic results aren't usually as good.
I think in your case and others like you, slow and steady wins the race. That means a much more conservative approach, with the knowledge you are only going to make smallish gains each round. This will give you much more control and if aesthetic issues do arise, they will be far easier for Dr C to fix.
Please Log in or Create an account to join the conversation.
Re: Taking the PMMA plunge
13 years 6 months ago #1276497806- Miracle8x7
-
- Offline
- Moderator
-
- Posts: 1328
- Thanks: 1
Please Log in or Create an account to join the conversation.
Re: Taking the PMMA plunge
13 years 6 months ago #1276499325Please Log in or Create an account to join the conversation.
Re: Taking the PMMA plunge
13 years 6 months ago #1276499721- Dance_With_Dragons
-
Topic Author
- Offline
- General
-
- Posts: 291
- Thanks: 0
Fine then, I will go conservative. But I just want to clarify that this is total bullshit and I hate you all right now. Thanks though. I really don't want to screw up my unit shooting for something that's unattainable. But you still all suck.
Please Log in or Create an account to join the conversation.
Re: Taking the PMMA plunge
13 years 6 months ago #1276499950- Dance_With_Dragons
-
Topic Author
- Offline
- General
-
- Posts: 291
- Thanks: 0
We worry about things so much, and we have no clue what floats their boat. Onward and upward.
Please Log in or Create an account to join the conversation.
Re: Taking the PMMA plunge
13 years 6 months ago #1276502101Please Log in or Create an account to join the conversation.
Re: Taking the PMMA plunge
13 years 6 months ago #1276505068Hoddle is there any merit in that?
Please Log in or Create an account to join the conversation.
Re: Taking the PMMA plunge
13 years 6 months ago #1276507980- Miracle8x7
-
- Offline
- Moderator
-
- Posts: 1328
- Thanks: 1
Please Log in or Create an account to join the conversation.